Solution for any Bosch Dishwasher Error Code

Turn off the power of the breaker for 30 seconds. Request Service

Turn off the power of the breaker for 30 seconds. Request Service

Turn off the power of the breaker for 30 seconds. Request Service

Turn off the power of the breaker for 30 seconds. Request Service

Turn off the power of the breaker for 30 seconds. Request Service

Turn off the power of the breaker for 30 seconds. Request Service

Turn off the power of the breaker for 30 seconds. Request Service

Turn off the power of the breaker for 30 seconds. Request Service

It’s time to descale your dishwasher. Your dishwasher can be descaled with Bosch dishwasher descaler. Limescale can build up quickly in dishwashers due to frequent use, especially in regions with hard water. Regular descaling is crucial to keep your dishwasher working properly and ensure clean dishes. Use softening salt in your dishwasher if it has a water softening function to prevent this problem from occurring again. Request Service

Ask an experienced technician for help. Request Service

Please stop the water supply. Phone a technician. Request Service

Make sure that the inlet hose is not kinked or broken by inspecting it.

1. Make sure that the inlet hose is not kinked or broken.
2. Make sure that the water supply is turned on. The recommended water flow rate is 10 l/min.

Turn off the power of the breaker for 30 seconds.

Turn off the power of the breaker Request Service

Turn off the power of the breaker Request Service

Reinstall the filter after removing it and cleaning it with mild soap and a delicate brush to get rid of any debris. Request Service

Use a sponge to clean the area around the drain hole. Remember that sharp objects, including bones and glass fragments, can get stuck in the drain hole. It is recommended to use a flashlight. Make sure that the impeller rotates freely by turning it by hand. Check the drain pipe for obstructions by removing it. Make sure it is not kinked or bent. Drain excess water from the machine. Use a tray or bucket. Reinstall the filter and connect the hose to the drain pipe. Place the mixture in a plastic jar after adding two to three teaspoons of bicarbonate to a cup of vinegar. After that, place it in the dishwasher. The door should be closed, lightly pressed and start the fast cycle. When the cycle starts, release the door (after about a minute).

1. Make sure that the inlet hose is not kinked or broken.
2. The pump cover may be loose. The pump cover is located at the bottom of the dishwasher, next to the filter. To open the pump cover and check that it is securely fastened, remove the filter. If you have difficulty finding it, refer to the user manual.
3. Make sure that the plug is removed from the dishwasher drain connection if the dishwasher drain hose is connected to the dishwasher drain connection.

Check if the drain pump cover is loose. The pump cover is located on the bottom of the dishwasher, next to the filter. Remove the filter to open the pump cover and check that it is secure. If you have difficulty finding it, refer to the dishwasher’s manual. There is a possibility that the drain pump is clogged. The pump is located under the filter at the bottom of the dishwasher. To access the drain pump cover, first, remove the filter completely. After that, use a spoon to pull the pump cover until it clicks. Pull upward while holding the cover until you feel resistance. Then pull forward to remove the cover completely. Use a sponge to clean the pump of debris and standing water. Be careful, as some debris particles may be sharp. Request Service

Turn off the power of the breaker for 30 seconds. Contact an electrician to check the input voltage of the appliance if the problem reappears Request Service

When it clears, repeatedly press the DELAY WASH button, and it will resume normal operation. Request Service

For 60 seconds, turn off the breaker, then check to see whether it clears. If not, a new control board is required. Request Service