Solution for any Samsung Dishwasher Error Code
- Licensed Technicians
- ODP Certified
- 24-hour telephone support
- 5 star reviews
Samsung Dishwasher Error Codes
1E, IE
Clean the dishwasher’s fine filter at the bottom. For instructions, read your user manual.
3C
Try restarting the cycle after turning off the dishwasher. Contact a technician if the error does not disappear Request Service
3E
Make sure the water temperature is not set above 176 degrees.
4C, 4E
Make sure that the water pressure and temperature meet the needs of the device. Samsung dishwashers do not work with flood-proof hoses, so do not use them. Make sure the water supply is turned on.
5C, SC, 5E, SE
Examine the sink’s drain connection to the dishwasher. Examine the drain hose. Water should be running in the sink to which the dishwasher is attached. Clean the tub’s filter, drain, and sump.
7E
Check to see if the packaging tape has been removed from the Waterwall reflector if you have just recently unboxed the dishwasher. Make sure the reflector is not blocked and installed correctly.
9E
Clean the dishwasher. After adding detergent, complete a typical cycle.
AP
A dishwasher should be turned off and back on again if you are not attempting to connect it.
bE, 6E
Turn the dishwasher off. Simply press each button on the panel.
CE
The dishwasher must be switched off and then restarted.
HC, 1E, IE
At the circuit breaker, turn the power to the dishwasher off for 30 seconds, then back on. Clean the dishwasher. Start the normal cycle when you have filled the detergent drawer.
HE
Clean out the dishwasher. After adding detergent, complete a typical cycle.
LC, LE
It’s possible that some water splashed close to the sensor after you recently moved the dishwasher. Let it dry for a while. Unplug the dishwasher or switch it off at the circuit breaker if the noise it makes concerns you. Make sure that the garbage compartment lid is closed if the dishwasher has been connected to the garbage compartment only. Make sure that the detergent dispenser is not overfilled and that there is no additional detergent outside it.
OC, 0C, oE
This is often closely related to the problem of drainage. Examine the sink’s drain connection to the dishwasher. Examine the drain hose. Water should be running in the sink to which the dishwasher is attached. Clean the tub’s filter, drain, and sump.
PC
A dishwasher should be turned off before attempting a new cycle start.
PE
Clean the dishwasher. Run a half-load cycle after adding detergent.
tE
Clean the dishwasher. After adding detergent, start a typical cycle.