AEG Washer Error Code E11

What does error code E11 in my AEG washing machine mean and how to fix it?

If your washing machine is displaying error codes E10, E11 or E12, it is most likely the washing machine is not filling with water properly or that the water level sensor is malfunctioning. This error might occur due to issues such as a clogged filter, a malfunctioning water inlet valve, or problems with the water supply.

Recommended solution/troubleshooting steps

To resolve the E11 error on your washing machine, you can follow these steps.

1. Check the water supply. Make sure that the water faucets connected to the washing machine are fully turned on and provide adequate water pressure.

2. Inspect the hoses. Examine the water inlet hoses for any kinks, twists, or damage that may be obstructing water flow. Straighten any kinks and ensure the hoses are securely connected to both the faucets and the washing machine.

3. Clean the inlet filter. Locate the inlet filter where the hoses connect to the washing machine. Remove the hoses and inspect the filter for any debris or blockages. Clean the filter thoroughly and reattach the hoses.

4. Test water pressure. Test the water pressure by disconnecting the hoses from the washing machine and placing them into a bucket. Turn on the water faucets and check if water flows freely from both hoses.

5. Reset the washing machine. If the above steps do not resolve the issue, try resetting the washing machine by unplugging it from the power source for a few minutes, and then plugging it back in.

6. Contact an appliance repair company. If the E11 error persists after troubleshooting, it may indicate a more complex issue such as a malfunctioning water inlet valve or sensor. In this case, contact AEG customer support or a qualified technician for further assistance and repair.

The error code E11 in an AEG washing machine is a fairly common problem. To avoid incorrect repairs and prevent additional damage, you should contact a specialist.