Solution for any Whirlpool Dryer Error Code
- Licensed Technicians
- ODP Certified
- 24-hour telephone support
- 5 star reviews
Whirlpool Dryer Error Codes
PF
In the event of a power outage, this code may be shown. To restart the cycle, press the “Start” button. After that, stop it to clear the display. If there are frequent power outages, check the appliance’s power cord.
F01
It is recommended to disconnect the device from the power supply for at least two minutes. Reconnect the power, let it run in standby mode for 30 seconds, and then try to start it again.
F05
Check if the pump filter is clogged. Also, check the water line under the sink and the waste water hose for blockages. If none of the above recommendations worked, you probably have a pump malfunction and will need additional assistance.
F06
Please inspect the door lock of your dryer for any obstacles if the door doesn’t close.
F23
This error indicates an electrical short circuit of the thermistor. To correct the fault, disconnect the device and check the resistance of the thermistor. It should be around 10,000 ohms. If it is damaged, contact a specialist. Request Service
F25
An electrically shorted temperature inlet sensor is discovered by the system. Cut the dryer’s power. Check the thermistor resistance after that. There must be 50,000 ohms or so. Replace the damaged inlet thermistor immediately. Keep in mind that the thermistor and the high-limit thermostat are combined. Request Service
F28
Unplug the appliance in this case and check the wiring connections on the sensor. Replace the sensor if everything is well. Request Service
F29
In this case, disconnect the dryer and check the sensor wire connections. If all is well, replace the sensor. Request Service
F30
Clean the lint screen in this situation. To get rid of fabric softener accumulation after using fabric softener sheets, wash them with water and a brush. Clear any obstructions from your home’s exhaust air duct system that are leading outside. Request Service
F3E2
You can restart the machine and erase the error code by pressing the “Power” button. If the problem persists, contact a service company. Request Service
F1E1
Attempt to reset the device by disconnecting and replugging the machine’s power cord into the wall socket if the power cord is accessible. Request Service
F20
Turn off the power supply by turning off the circuit breaker(s) for one (1) minute. Turn on the power supply by turning on the circuit breaker(s). Start the timed drying cycle. Observe the dryer operation for one (1) minute to ensure that the error code does not reappear. Request Service
WHY CHOOSE SUPERIOR APPLIANCE SERVICE
Over 400 positive reviews on Google Maps and HomeStars.
Repair on the same day or any other date convenient for you.
All work and parts guaranteed for your peace of mind.
Adequate prices. 9 out of 10 problems are solved after the first call. No overpayments.
Want to know if you need a handyman to solve your problem?
Leave your phone number and our dispatcher will call you back right away!
Thank you.
We will contact you. Shortly.