Solution for any LG Dishwasher Error Code

Examine the drain bend or valve

This signal indicates that there are less than two hours left for the system to continue operating. It is not an error.

Check that no flaw in the dishwasher’s spray arms is allowing water to spray directly at the door gasket or another part that might be draining the water to the drain pan. Replace any broken parts and inspect the hoses (some may need their filters cleaned). Recall that replacing a hose is preferable to attempting to mend one.

Check for issues with the following: washer installation, door leaks, proper washer loading, working sump motors, float assemblies, and leaking sump assemblies.

An issue with the intake is indicated by this error. To fix it, determine whether or not the hose is obstructed. Make sure the taps are open as well.

This error code indicates a motor issue with the dishwasher. To solve the problem, take the following actions:

1. To turn off the dishwasher, press the “Power” button in step one.
2. Switch the circuit breaker off.
3. Wait ten seconds.
4. Switch the CB on.
5. Press the “Power” button to start the dishwasher.
6. Start a new cycle.

It indicates a motor issue. To solve this problem, adhere to the methods listed below:

1. To turn off the dishwasher, press the “Power” button in step one.
2. Switch the circuit breaker off.
3. Wait ten seconds.
4. Switch the CB on.
5. Press the “Power” button to start the dishwasher.
6. Start a new cycle.

It indicates a problem with filling the dishwasher with water. The drain pump turns on automatically when the dishwasher detects an excessive volume of water. To solve the problem, follow these steps:

1. To turn off the dishwasher, press the “Power” button in the first step.
2. Wait for approximately 10 seconds.
3. Plug in the dishwasher.
4. Press the “Power” button to start the dishwasher.
5. Start a new wash cycle.

If the dishwasher overheats or cannot heat the water, this code may appear. To fix this problem, follow the methods below:

1. To turn off the dishwasher, press the Power button in the first step.
2. Wait for approximately 10 seconds.
3. Plug in the dishwasher.
4. Press the “Power” button to start the dishwasher.
5. Start a new wash cycle.

You might get this error code to prevent more serious issues brought on by power outages. You must press and hold any button on the dishwasher control board for 10 seconds after the power is restored. The display will thereafter be cleared. Check the circuit breaker if the PF error repeatedly occurs without any power issues. It might not meet the dishwasher’s electrical requirements. In this situation, use an appropriate CB to power your dishwasher.

This will occur if the water temperature is above 194 degrees or if there is a problem with the thermistor. If the tE error code persists, the unit will require repair.