Solution for any GE Dishwasher Error Code
- Licensed Technicians
- ODP Certified
- 24-hour telephone support
- 5 star reviews
GE Dishwasher Error Codes
C1
It is necessary to check the drain hose, drain valve, air gap, drain line and pump impeller. The probability that one of these parts is defective is very high. It can be difficult for a non-specialist to find and clean them all. In addition, if one of them is broken, a new one must be installed in its place. Please contact a specialist. Request Service
C2
A dishwasher cannot remove water by pumping it out. It is set up to complete this task in less than 7 minutes. When the pump-out timer expires, a device begins to beep. You must look at the drain line to find the cause of the issue. It might be blocked, which would result in this error. If yes, make sure all the debris is removed. Request Service
C3
This problem is related to the drain mode. The dishwasher is not able to switch to it. It is difficult for the homeowner to solve this problem. You can only restart the device. Request Service
C4
Restart the device to solve this problem. Check the float if the problem persists. It resembles a cup turned upside down inside the machine. The sump can also be checked for obvious obstructions and debris. It is installed on the back of the machine close to the ground. It looks like a basket.
C5
To eliminate the error, check the pressure on the device. Also, make sure that the float switch and inlet valve are working properly.
C7
First, restart the device. Check the wiring connections if the problem persists. C7 may appear due to a loose wire connection. If the wire connection is secure, you may need to replace the water temperature sensor or control board. Request Service
C8
The detergent cup does not open for some reason. If necessary, clean it from debris. If this does not help, the cup may be broken. Purchase a new detergent container to replace the broken one. Request Service
E8
When a dishwasher wash program is started, and the appliance does not detect a signal from the alternate valve indicating that the alternate valve is properly installed, an error code is generated. A faulty alternate valve may cause this error, but not necessarily. Before manually ensuring that the motor and gears are freely rotating, use an ohms multimeter to check the switch’s continuity; The issue can be limescale. Clean it or call a technician to examine the device. Request Service
1h
The GE dishwasher will start the wash cycle if you start it and wait one hour. Press the START button repeatedly until the delayed start is stopped. After that, you can use the dishwasher as usual.
E4
On the right side of the dishwasher, there is a tank with an overflow sensor. To reset the sensor, it is necessary to drain the water from the tank. If necessary, remove the black rubber plug at the base of the plastic tank and remove the insulation from the bottom front corner of the machine before emptying the contents into a cup or container.
E1
Please make sure there are no leaks by checking the drain pipe at both ends. Also, check that there is no leakage under the dishwasher itself. If there is no leakage, make sure that the impeller is securely attached and not damaged. Request Service
WHY CHOOSE SUPERIOR APPLIANCE SERVICE
Want to know if you need a handyman to solve your problem?
Leave your phone number and our dispatcher will call you back right away!
Thank you.
We will contact you. Shortly.