Common Whirlpool Washer Error Codes
- Licensed Technicians
- ODP Certified
- 24-hour telephone support
- 5 star reviews
Whirlpool Washing Machine Error Codes
SUD
Drain your washing machine, then start it up again to clear the error code.
F25
Check the contacts of the connectors. If they are twisted, bowed, or out of the groove, straighten them out before firmly inserting them into the socket.
F0E1
Turning your washer on and off will reset it. Call a technician if it doesn’t work after that. Request Service
F3E1
Turn off the circuit breaker or unplug the device for one 1 minute to shut it down. Reconnecting the power will start the device. Start a new cycle. For one minute, keep an eye on the washer to make sure the problem code doesn’t appear again. Request Service
F3E2
Check the wiring connections between the temperature sensor and the control board. If they’ve been harmed, fix them. Request Service
F5E1
It is important to test the door switch. If it’s merely stuck in the wrong place, try wiggling it. If it breaks, replace it. Request Service
F5E2, F5E3
Check to see that the lock tab on the door is intact and not damaged. A multimeter should be used to test the door lock to see if the tab is in good condition. Request Service
F6E2
Check the functionality of the wiring that connects the user interface to the main control board. The wiring that is damaged has to be replaced. If no damage is visible, use a multimeter to check the connections. Request Service
F8E3
Examine the pressure sensor, drain pump, and water inlet valve. You should get new ones if any of them aren’t functioning. Request Service
F9 E1
Check that the drain hose is properly installed. Request Service
F71
Look for loose connections or damaged cabling in the wiring that connects the user interface control boards to the central control unit. Request Service
LE
The motor will be stressed by large and heavy loads, resulting in the LE code. Reduce the load. Request Service
LF (too long to fill)
The drain hose may extend more than 4.5 inches (114 mm) into the standpipe. Check that the drain hose is properly installed. Request Service
F02
Check for obstructions in the pump filter as soon as possible. Check your drain hose and tub to pump hose for blockages if your washer still won’t drain properly after cleaning the drain pump filter. You should replace the drain pump if the hoses are clear. Request Service
E2
Check the following: Make sure the drain hose is no higher than 3913″ (100 cm) from the ground. Remove any obstructions in the drain tube.
E1
Check if the water supply is blocked.
PE
The washing machine will not work if the pressure level sensor fails, it will need to be replaced. Request Service
F6 E3
Unplug the washing machine for five minutes and plug it back in.
WHY CHOOSE SUPERIOR APPLIANCE SERVICE
Over 400 positive reviews on Google Maps and HomeStars.
Repair on the same day or any other date convenient for you.
All work and parts guaranteed for your peace of mind.
Adequate prices. 9 out of 10 problems are solved after the first call. No overpayments.
Want to know if you need a handyman to solve your problem?
Leave your phone number and our dispatcher will call you back right away!
Thank you.
We will contact you. Shortly.